|
Instrument Database:
Labconco Corporation - Protector® Stainless Steel Perchloric Acid Laboratory Hoods
| |
|
|
| |
|
| |
|
| Year of introduction |
|
| Status |
available |
| Company |
Labconco Corporation
|
| Categories |
Laboratory facilities: Extractor hoods
|
|
Protector Stainless Steel Perchloric Acid Laboratory Hoods are designed specifically for procedures involving the use of perchloric acid. They feature washdown systems, integral work surfaces and drainage troughs so that they may be thoroughly rinsed after each use to prevent the accumulation of potentially reactive perchloric salts.
Available in 4, 5, 6 and 8-foot widths, these benchtop hoods feature a corrosion-resistant Type 316 stainless steel interior to withstand reaction from perchloric acid. The one-piece liner is free of joints, cracks or crevices to prevent build-up of residue and simplify decontamination procedures. Compliance
- SEFA 1-2002 (Laboratory Fume Hoods)
- NFPA 45-2000 (Fire Protection for Laboratories Using Chemicals) section 6-1 through 6-14
- ASTM E84-01 Surface Burning Characteristics of Building Materials
- ASHRAE 110-95 (Method of Testing Performance of Laboratory Fume Hoods)
- ANSI Z9.5-1993 (Laboratory Ventilation)
- UL 3101-1/61010-1
- CAN/CSA C22.2 No. 1010.1
- UL 1805
Features
- By-pass airflow design
- Curved air foil allows air to sweep the work surface while Clean-Sweep™ openings pull inflow air from under the air foil.
- Glacier white, dry powder epoxy-coated steel exterior
- Seamless Type 316 stainless steel liner (23.5" interior depth) with integral work surface and drainage trough
- Black enamel-coated hardboard surface to support the integral work surface
- 3/16" thick tempered safety glass vertical-rising sash with frame of epoxy-coated aluminum and PVC
- Removable front and side panels and front access panels for access to plumbing and electrical wiring
- Energy-efficient T8 fluorescent lighting,
- Light switch and blower switch for 115 volt, 60 Hz operation pre-wired to a single point internal junction box
- Two pre-plumbed service fixtures with forged brass valves and chrome-plated brass serrated hose connectors, lower right side with brass tubing for gas and lower left side with copper tubing for air
- Pre-wired 115 volt electrical duplex receptacle on lower right side
- Built-in washdown system with internal piping and spray nozzles behind the baffle and remote control fixture on the left side
- Washdown port for connection to external wash rings (wash rings sold separately)
- ETL Listed
- 11" OD Type 316 stainless steel exhaust connection(s)
Options
• 4', 5', 6' and 8' widths
|
|
