|
Instrument Database:
Labconco Corporation - Protector® PVC Perchloric Acid & Acid Digestion Laboratory Hoods
| |
|
|
| |
|
| |
|
| Year of introduction |
|
| Status |
available |
| Company |
Labconco Corporation
|
| Categories |
Laboratory facilities: Extractor hoods
|
|
Protector PVC Perchloric Acid Laboratory Hoods feature washdown systems, integral work surfaces and drainage troughs so that they may be thoroughly rinsed after each use to prevent the accumulation of potentially reactive perchloric salts. Their liners of Type 1 unplasticized polyvinyl chloride are designed to withstand reaction from perchloric acid.
Protector PVC Acid Digestion Laboratory Hoods feature Lexan* polycarbonate sashes, which are recommended for applications involving the use of acids including hydrofluoric acid but not perchloric acid. The Lexan material does not fog or etch when exposed to hydrofluoric fumes.
These benchtop hoods are available in 4, 6 and 8-foot widths. They feature heat-welded unplasticized PVC liners, built-in washdown systems, integral work surfaces and drainage troughs. Compliance
- SEFA 1-2002 (Laboratory Fume Hoods)
- NFPA 45-2000 (Fire Protection for Laboratories Using Chemicals) section 6-1 through 6-14
- ASTM E84-01 Surface Burning Characteristics of Building Materials
- ASHRAE 110-95 (Method of Testing Performance of Laboratory Fume Hoods)
- ANSI Z9.5-1993 (Laboratory Ventilation)
- UL 3101-1/61010-1
- CAN/CSA C22.2 No. 1010.1
- UL 1805
Features
- By-pass airflow design
- Curved air foil allows air to sweep the work surface while Clean-Sweep™ openings pull inflow air from under the air foil.
- Glacier white, dry powder epoxy-coated steel exterior
- Heat-welded unplasticized PVC liner (30.0" interior depth) with integral work surface and drainage trough
- Black enamel-coated hardboard surface to support the integral work surface
- 3/16" thick tempered safety glass vertical-rising sash with frame of epoxy-coated aluminum and PVC (Protector PVC Perchloric Acid Laboratory Hoods)
- 1/4" thick Lexan* polycarbonate vertical-rising sash with frame of epoxy-coated aluminum and PVC (Protector PVC Acid Digestion Laboratory Hoods)
- Removable front and side panels and front access panels for access to plumbing and electrical wiring
- Pre-wired T8 fluorescent lighting, light switch and blower switch for 115 volt, 60 Hz operation to single point internal junction box
- Built-in washdown system with internal piping and spray nozzles behind the baffle and remote control fixture on the left side
- Washdown port for connection to external wash rings (not included)
- Two pre-plumbed service fixtures with forged brass valves, lower right side with brass tubing and plastic serrated hose connector for gas and lower left side with copper tubing and gray PVC rigid gooseneck faucet for cold water.
- One pre-wired 115 volt electrical duplex receptacle on lower right side
- Factory prepared for up to seven service fixtures including two gooseneck faucets
- Factory prepared for up to four electrical duplex receptacles
- ETL-Listed
- 12.75" OD PVC exhaust connection(s)
Options
|
|
