Manufacturing Standards
Meets applicable safety and EMC certification standards; UL and CE certified
Available Valves
Rheodyne 7010
Rheodyne 7413
Communication Interface
RS-232 or GSIOC; Four inputs + one analog signal (10 or 100 mV), four outputs, three relay outputs and two 12V power supplies
Carryover
<0.0001% with liquid level detection and recommended needle rinsing parameters; <0.005% without liquid level detection
Environmental Conditions
Indoor use
Altitude: up to 2000 m
Temperature range: 5–40°C
Air pressure: 75–105 kPa
Pollution degree: 1 or 2, in accordance with IEC 66
Humidity: Maximum relative humidity 80% for temperatures up to 31°C, decreasing linearly to 50% relative humidity at 40°C
Flow Rate
0.01 mL to 120 mL/min
Injection Volume
0.5 µL to 5 mL
Liquid Contact Materials
316L stainless steel or titanium, FEP, PTFE, PEEK, PP, PE
Number of Solvents
Up to 15 solvent bottles with no volume limit, plus up to 12 solvent bottles (250 mL) on the tray
Power Requirements
Frequency: 50–60 Hz
Voltage: 100–120 or 220–240V, mains voltage fluctuations not to exceed ±10% of the nominal voltage
Precision
Total loop fill: RSD=0.5%
Partial loop fill: RSD=0.7%
Sample Preparation Capability
All SPE steps (condition, load, wash, elute) including SPE cartridge drying (gas valve fitted as standard). Multicollect and multicartridge methods. Reagent and internal standard addition, derivatization, dilution, mixing. With advanced programming options (link method, sub method).
Sample/Reagent Vessels
3.5-mL (10 x 75 mm), 9-mL (13 x 100 mm), and 20-mL (16 x 150 mm) tubes and 2-mL (12 x 32 mm) autoinjector vials
Software
Via Gilson 735 Sampler Software
Local control via Gilson XL keypad with 720 software
Syringe Capacity
100, 250, or 500 µL; 1, 5, 10 (standard), or 25 mL
Temperature Control
Optional Peltier Controller (4° to 40°C)
Transfer of the Extract
The extract can be automatically transferred into open or sealed autoinjector vials for further analysis
1-mL SPE Cartridge (10 to 200 mg, or 4-mm disk)
Sample/cartridge capacity: 108
Max. collection volume: 5 mL
Multiple collection: Up to 9 fractions per cartridge
3-mL SPE Cartridge (200–500 mg, or 7-mm disk)
Sample/cartridge capacity: 80
Max. collection volume: 5 mL
Multiple collection: Up to 5 fractions per cartridge
6-mL SPE Cartridge (500–1000 mg, or 12-mm disk)
Sample/cartridge capacity: 28
Max. collection volume: 15 mL
Multiple collection: Up to 5 fractions per cartridge
Dimensions (w x d x h)
51.5 x 62 x 30 cm (20.3 x 24.4 x 11.8 in.)
Weight
17 kg (37.5 lbs.)